Terms & conditions of VersaTrigger website usage

VersaTrigger Trigger your creative photography

VersaTrigger ωave

The VersaTrigger ωave control unit is an easy to use device which, via the remote unit, will trigger either a camera or a flash unit from a wide variety of input sensors, these currently include:







Operation is straightforward, the controls are





All connectors are readily available and may be extended using either standard extension cables or those available through VersaTrigger:




The power supply is a standard 9 volt PP3 battery, this is easily fitted by removing the back cover (no screwdriver is necessary).

The VersaTrigger ωave remote unit has an on/off switch, an output connector and not really much else.

Connect it to your camera or flash, switch on and it’s ready.  Whenever the control unit senses an input it will trigger the remote, have more remotes switched on they will all trigger.


Trying to get a photograph of that tiger in your back garden but not sure which direction he will appear from?  Set up two controls with PIR sensors, one at either side and have a remote with your camera in the centre.  Adjust the delays to let him walk in front of your camera and you have a photograph of the elusive urban tiger.

All accessories and camera cables are compatible with both the VersaTrigger and the VersaTrigger ωave.

The power supply is a standard 9 volt PP3 battery, this is easily fitted by removing the back cover (no screwdriver is necessary).


The VersaTrigger ωave is a remote - control system with a range of at least 10 metres, sensors may be plugged into the control while the remote is connected to a camera or a flash.  It is a single channel device which means that additional control units or remotes may be added to the system creating a total area coverage system.

Primarily designed for wildlife photography, the ωave system is equally at home in the studio where long wires may present a hazard.